 
Config * IP Port Parameters Module: BladeRunner
Log. Port: 1 LOGICAL PORT Time: 15:55 9 Jan 95
IP Port Routing: Enabled Disposition: discard
RIP: Enabled * IP Mtu: 1492
RIP Path Cost: 1 LAN Encapsulation: ethernet
Broadcast Form: ones Forward Broadcast: Enabled
Security Access List 1: 0 Security Access List 2: 0
Search Port Prev Port Next Port Exit
Return to the previous screen
 
Figure 164. LMS IP Port Parameter Panel
This panel allows you to display and configure IP parameters for each logical
port. The following parameters can be specified on this panel:
•
IP Routing
This parameter allows you to enable IP routing for each port. Note that
to perform IP routing, IP routing must be enabled at both the module
and port level.
•
Disposition
This parameter is valid if the IP routing is disabled at the port level but
enabled at the module level. It specifies if the IP traffic received at the
port level is bridged or discarded.
•
RIP
This parameter controls whether RIP is enabled or disabled for this port.
•
IP Mtu
This parameter specifies the maximum size of the IP packets that may be
transmitted on this port.
•
RIP Path Cost
This parameter specifies the RIP path cost assigned to this logical port.
•
LAN Encapsulation
This parameter specifies the LAN encapsulation used to transmit a
datagram on this port. Note that for Ethernet connections you can
choose Ethernet or 802.3 but not both.
•
Broadcast Form
This parameter specifies which form of broadcast (all 0′s or all 1′s) is
used by the module to send broadcast messages on this interface. Note
Chapter 11. 8260 Multiprotocol Interconnect Module 283