This parameter determines if the RIP filter table will be used for importing routes found by RIP. RIP filter table is discussed later in this section.
∙Import Static Routes
This parameter determines if the static route filter table will be used for importing static routes. Static route filter table is discussed later in this section.
∙Default Action on No Match for RIP Routes
This parameter specifies the action to be taken when a RIP route does not match any entry in the RIP filter table. If this parameter is set to import, a route found by RIP that does not have a match in the RIP filter table is imported using the default
∙Default Action on No Match for Static Routes
This parameter specifies the action to be taken when a static route does not match any entry in the static route filter table. If this parameter is set to import, a static route that does not have a match in the static route filter table is imported using the default
2.Define the interfaces that are enabled for OSPF. To do so, you must select OSPF Interface Table from the OSPF Menu. An example of the resulting panel is shown in Figure 170.
|
|
|
|
|
|
|
| ||
Config * |
| OSPF Interface Table | Module: BladeRunner |
| |||||
|
|
|
| ||||||
| System |
|
| Page 1 | Time: | 17:40 11 Jan | 95 |
| |
| IP Address | Port | Area ID | Type | AdminStat | Priority | PollInt | ||
9.67.46.17 | 0 | 0.0.0.0 | broadcast | Disabled | 1 | 120 |
| ||
9.67.46.44 | 0 | 0.0.0.0 | broadcast | Enabled | 1 | 120 |
| ||
9.67.46.94 | 0 | 0.0.0.0 | broadcast | Disabled | 1 | 120 |
|
Modify Entry | Prev Page | Next | Page | Exit |
Return to the previous screen |
|
|
|
| ||
Figure | 170. LMS OSPF Interface Table Panel |
This table allows you to specify the
290 8260 Multiprotocol Intelligent Switching Hub