Table 110. Abort Condition Handling (continued)
Command | Abort Processing |
|
|
RECEIVE DIAGNOSTIC | None. |
RESULTS |
|
|
|
RELEASE UNIT | The command completes. |
|
|
REPORT DENSITY | None. |
SUPPORT |
|
|
|
REPORT LUNs | None. |
|
|
REQUEST SENSE | Sense data is discarded. |
|
|
RESERVE UNIT | The command completes. |
|
|
REWIND | The command completes. |
|
|
SEND DIAGNOSTIC | Vendor unique. |
|
|
SPACE | The logical position is set back to that at the start of the |
| operation unless the operation is past its ‘point of no return’, |
| in which case the operation completes. |
|
|
TEST UNIT READY | None. |
|
|
VERIFY | The logical position is set to the next record boundary after |
| the point where the verify was aborted. |
|
|
WRITE | The data up to first record boundary in the current burst is |
| written to buffer or tape, depending on Buffered Mode. Any |
| subsequent data is discarded. If there is no record boundary |
| in the current burst, the record is truncated to the amount of |
| data transferred and written to buffer or tape, again |
| depending on Buffered Mode. |
|
|
WRITE BUFFER | If data transfer is completed, the command is completed; |
| otherwise, no action is taken. |
|
|
WRITE FILE MARKS | The command completes. |
|
|
For drives with a SCSI interface, if a command other than INQUIRY, REPORT LUNs, REQUEST SENSE, or TEST UNIT READY is received after the abort but before the drive is ready to process the command, the drive attempts to disconnect and wait until the abort processing has completed before executing the command. If disconnects are not allowed, Busy status is returned. A TEST UNIT READY command reports with status immediately.
For drives with a Fibre Channel interface, an INQUIRY command returns the required data and gives Good status. A REQUEST SENSE command gives no sense. A TEST UNIT READY command reports with status immediately.
Chapter 5. Attachment Features 95