Messages
Message Out
Table 112. Supported Outbound Messages
Name | Code | Support |
|
|
|
Abort | 06h | An abort condition is generated (see “Abort Handling” on |
|
| page 94). |
|
|
|
Bus Device Reset | 0Ch | A reset condition is generated (see “Abort Handling” on |
|
| page 94). |
|
|
|
Extended Message | 01h | See “Unit Attention Conditions” on page 87 for extended |
|
| message support. |
|
|
|
Identify | 80h+ | The Identify Out message is sent by the initiator to identify |
|
| the Logical Unit to be accessed and to set Disconnect |
|
| Privilege. The LUNTAR flag must be 0. The Identify Out |
|
| message must be sent as the first thing after selection. If it |
|
| is sent at any other time, the drive responds with a |
|
| Message Reject message and goes to Bus Free. |
|
|
|
Initiator Detected | 05h | The initiator has detected an error in the data being sent |
Error |
| in a Message Command, Data, or Status phase. The drive |
|
| retries the data burst or message (see “Bus Parity Errors” |
|
| on page 97). If the message is received immediately after |
|
| an Identify message or after the Command Complete |
|
| message has been sent, the drive goes to Bus Free. |
|
|
|
Message Parity Error | 09h | The initiator has detected a parity error in a message. The |
|
| drive retries the message (see “Bus Parity Errors” on page |
|
| 97). If the message is received during a Command, Data, |
|
| or Status phase, immediately after an Identify message, or |
|
| after the Command Complete message has been sent, the |
|
| drive goes to Bus Free. |
|
|
|
Message Reject | 07h | This message is sent when the initiator does not support a |
|
| message sent by the drive or considers the message |
|
| inappropriate. If the message being rejected is Disconnect, |
|
| Synchronous Data Transfer Request, or Wide Data |
|
| Transfer Request, the operation continues without those |
|
| features. For all other messages except Restore Pointers, |
|
| the message is treated as an Abort message. If the |
|
| message is received during a Command, Data, or Status |
|
| phase, immediately after an Identify message, or after the |
|
| Command Complete message has been sent, the drive |
|
| goes to Bus Free. |
|
|
|
No Operation | 08h | This message has no effect and is ignored. |
|
|
|
98Ultrium Internal Tape Drive and 3580 Ultrium Tape Drive: SCSI Reference