Settings menu

To adjust the following Settings options, go to Main Menu -> Settings.

Audio: Allows adjustments to the sound balance between speakers and speaker volume. The Internal speakers and projector startup Chime can be turned on or off by placing or removing a check in the respective checkboxes.

Sources ->Power-up Source: This determines which source the projector checks first for active video during power-up.

Sources: Allows you to assign a particular input to a specific source key as an optional full-featured remote. Also allows selection of a default Power-up Source and enables or disables Autosource. When Autosource is not checked, the projector defaults to the source selected in Power-up Source. If no source is found, a blank screen displays. When Autosource is checked, Power-up Source determines which source the projector defaults to at power-up. If no signal is present, the projector checks the sources in order until a source is found or until power down.

System -> Rear: Reverses the image so you can project from behind a translucent screen.

Ceiling: Turns the image upside down for ceiling-mounted projection.

Note: It is recommended that all final image adjustments in Ceiling mode are made once the unit has fully warmed up.

Auto Power: When Auto Power is checked, the projector automatically goes into the startup state after the projector is powered on. This allows control of ceiling mounted projectors with a wall power switch.

Display Messages: displays status messages (such as “Searching” or “Mute”) in the lower-left corner of the screen.

Low Power: Toggles between on and off. Turn it on to lower the light output of the lamp. This also lowers the fan speed, making the projector quieter.

22IBM iLC300 Conference Projector: IBM iLC300 Conference Projector User’s Guide

Page 32
Image 32
IBM Partner Pavilion iLC300 manual Settings menu