Integra DTR-5.3 instruction manual Connecting a DVD Player with 2-Channel L/R Audio Output

Connections (DTR-6.3)

Connecting a DVD Player with 2-Channel (L/R) Audio Output

ANTENNA	FM 75	AM			R	PHONO IN			GND
							L
									COMPONENT VIDEO
								INPUT 2 INPUT 1		OUTPUT
12 V					ZONE 2		RS232				Y
TRIGGER
OUT	IR OUT		ZONE 2 DC IN		LINE OUT
	56K	40K
A		A	OUT	24V 1A		L					PB
		B									REMOTE
B						R				PR CONTROL
	ZONE 2						VIDEO 1
DIGITAL INPUT		DIGITAL		VIDEO 3	VIDEO 2				DVD	MONITOR	IR
		OUTPUT COAXIAL		IN	OUT	IN	OUT	IN	IN	OUT
OPTICAL		OPTICAL									OUT
2	1										V
											IN
											S
			COAXIAL
			DIGITAL
			INPUT
	IN	OUT	IN	IN	OUT	IN	OUT	IN	FRONT	SURR	CENTER
	L									L
SUBWOOFER
PRE OUT
	R									R
											SUB
	CD	TAPE		VIDEO 3	VIDEO 2		VIDEO 1
											WOOFER

DVD

: Signal flow

4. Connecting a DVD player (DVD)

Using an RCA video cable, connect the video output jack (composite) of the DVD player to the DVD VIDEO IN jack of the DTR-6.3. Or if the DVD player has an S video output jack, connect it to the DVD S VIDEO IN jack with an S video cable. Or if the device has component video outputs, connect them to the COMPONENT VIDEO INPUT 1 or 2 jacks on the DTR-6.3.

With the initial settings of the DTR-6.3, the DVD input source is set for the COMPONENT VIDEO INPUT 1 jacks.

If you connect the DVD player to the COMPONENT VIDEO INPUT 2 jacks, this must be changed at “Input Setup” → “Component Video” (see page 53).

Using an RCA audio connection cable, connect the audio output jacks of the DVD player to the DVD FRONT L/R jacks of the DTR-

6.3.Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

If the device has a 5.1-channel output, connect the DVD FRONT L/ R, SURR L/R, CENTER, and SUBWOOFER (5.1-channel input) jacks of the DTR-6.3 to the 5.1-channel output jacks of the DVD player. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks.

If the device has a digital output, connect it to either the DIGITAL INPUT COAXIAL jack or the DIGITAL INPUT OPTICAL jack of the DTR-6.3 depending on the type of connector on the DVD player.

With the initial settings of the DTR-6.3, the DVD input source is set for digital input at the COAXIAL jack (COAX).

If the digital connection is made at a different jack, this must be changed at “Input Setup” → “Digital Input” (see page 53).

Note:

If the DVD player has both 5.1-channel audio outputs and 2-channel audio outputs, and you want to connect the DVD player only using the FRONT L/R jacks on the DTR-6.3, use the 2-channel audio output jacks on the DVD player.

Y

PB Component video output

PR

Video ouput

S video output

4. DVD player (DVD)

L (white)

Analog audio output R (red)

Digital audio output (coaxial)

18