Integra DTR-5.3 Supplied accessories, Before using this unit, Using the remote controller

Supplied accessories

Check that the following accessories are supplied with the DTR-6.3/5.3.

AM loop antenna ⋅ 1 FM indoor antenna ⋅ 1

Power cord ⋅ 1

Front Left	Front Left	/Zone2	Left	/Zone2	Left	Front Right	Front Right	/Zone2	Right	/Zone2	Right
		SP-B		SP-B				SP-B		SP-B
Front Left	Front Left	SP-B / Zone 2	Left	SP-B / Zone 2	Left	Front Right	Front Right	SP-B / Zone 2	Right	SP-B / Zone 2	Right
				1						2

Surround	Left
Surround	Left

Surround	Left
Surround	Left

Surround	Right	Surround	Right
Surround	Right	Surround	Right
		3

CenterCenter

CenterCenter

SurroundBack	Left	SurroundBack	Left	Zone2	Left	Zone2	Left
Surround Back	Left	Surround Back	Left	Zone 2	Left	Zone 2	Left

Surround Back	Right
Surround Back	Right

Surround Back	Right
Surround Back	Right

Zone 2	Right
Zone 2	Right

Zone 2	Right
Zone 2	Right

Speaker Cable

Remote controller (RC-481M) ⋅ 1	Speaker cable label ⋅ 1	Protective caps
Batteries (AA, R6 or UM-3) ⋅ 2		For digital jack ⋅ 1
		For analog jack ⋅ 1
		Protective caps for the Video4 jacks
		on the front of the DTR-6.3/5.3. Be
		sure to always attach the protective
		caps when you are not connecting a
		device to the VIDEO 4 jacks.

Before using this unit

Installing the remote controller batteries

1.Remove the battery compartment cover by pressing it and sliding it in the direction shown by the arrow below.

2.Insert two AA (R6 or UM-3) batteries into the battery compartment. Carefully follow the polarity diagram (positive (+) and negative (–) symbols) inside the battery compartment.

3.After the batteries are installed and seated correctly, replace the compartment cover.

1 2 3

Using the remote controller

Point the remote controller toward the remote control sensor. The STANDBY indicator lights up when the unit receives a signal from the remote controller.

Remote control sensor DTR-6.3/5.3

STANDBY indicator

30˚

30˚

Approx. 16 feet (5 meters)

Notes:

•Do not mix new batteries with old batteries or different kinds of batteries.

•To avoid corrosion, remove the batteries if the remote controller will not be used for a long time.

•Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, remove the old batteries and replace them both with two new AA batteries.

Notes:

•Make sure that the remote control sensor is not subject to strong light such as direct sunlight or inverted fluorescent light for it may prevent proper operation of the remote controller.

•Using another remote controller in the same room or using the DTR-6.3/5.3 near equipment that uses infrared rays may cause operational interference.

•Do not put objects on the remote controller. Its buttons may be pressed by mistake and drain the batteries.

•Make sure the audio rack doors do not have colored glass. Placing the DTR-6.3/5.3 behind such doors may prevent proper remote controller operation.

•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.

7