Connecting the power

Diagram for DTR-6.3

Standby/On

Standby indicator

On

Standby

 

 

RCVR

 

 

 

Mode

 

To wall outlet

Before you plug in the DTR-6.3/5.3, confirm that all connections have been made properly.

Turning on the power may cause a momentary power surge, which might interfere with other electrical equipment on the same circuit, such as computers. If this happens, use a wall outlet on a different circuit.

Turning on the power from the remote controller

Before you can use the remote controller, you must perform step 1 above and place the DTR-6.3/5.3 in the standby state.

1. Press the RCVR Mode button.

The RCVR Mode button lights green.

Turning on the power

1.Plug the power cord into an AC wall outlet.

The Standby indicator will light up.

2.Press the Standby/On button to turn on the DTR-6.3/ 5.3.

The display will light up and the Standby indicator will turn off. If you press the Standby/On button again, the receiver returns to standby state.

Turn off

2. Press the ON button to turn on the DTR-6.3/5.3 (take it out of the standby state).

To return the DTR-6.3/5.3 to the standby state, press the Standby button.

Memory preservation

The DTR-6.3/5.3 does not require memory preservation batteries.

Abuilt-in memory backup system preserves the contents of memory (e.g., speaker settings and surround settings) during power failures and even when the unit is unplugged. The unit must be plugged in order to change the back-up system.

The length of time that the memory will be preserved will vary depending on the ambient climate. On the average, memory contents are protected over a period of a few weeks after the last time the unit has been unplugged. This period may be shorter when the unit is exposed to a highly humid climate.

34

Page 34
Image 34
Integra DTR-5.3 instruction manual Connecting the power, Turning on the power from the remote controller