Connections (DTR-6.3/5.3)

REMOTE CONTROL

The terminal on the DTR-6.3/5.3 is for connecting other Integra/

Onkyo components equipped with the same terminal. When a

component is connected to the terminal, it can be operated by the remote controller supplied with the DTR-6.3/5.3. In addition, when

you connect a component to the terminal, you can also perform the system operations given below.

Power on/ready function

When the DTR-6.3/5.3 is in the standby state, if an -connected component is turned on, the DTR-6.3/5.3 also turns on and the input source selected at the DTR-6.3/5.3 automatically switches to that component.

Be aware that this function will not work if the power cord for the -connected component is connected to the AC OUTLET on the

DTR-6.3/5.3, or if the DTR-6.3/5.3 has already been turned on.

Direct change function

When the play button is pressed at an -connected component, the input source selected at the DTR-6.3/5.3 automatically changes to that component.

Power off function

When the DTR-6.3/5.3 is placed in the standby state, all - connected components are also automatically put into the standby state.

Also, if you press the On button on the DTR-6.3/5.3 remote

controller while the DTR-6.3/5.3 is turned on, all -connected components (DVD players, CD players, MD recorders, tuners, etc.) are also turned on.

Caution:

If an MD recorder is connected to the TAPE jack on the DTR-6.3/ 5.3, switch the Input Selector from TAPE to MD (see page 45).

DTR-6.3/5.3

connector

Ex: Integra/Onkyo CD player

connector

Ex: Onkyo cassette tape deck

To connect components using the terminal, simply connect a

remote control cable from this terminal to the terminal of the

other component. An remote control cable with a 1/8-inch (3.5-

mm)miniature two-conductor plug comes with every cassette tape deck, compact disc player, MD recorder, and DVD player that has an terminal.

When performing operations with -connected components

using the system, do not use the remote zone (Zone 2) (DTR- 6.3 only).

For remote control operation, the audio connection cables must also be connected.

If a component has two terminals, you can use either one to connect to the DTR-6.3/5.3. The other one can be used to daisy chain with another component.

With Integra/Onkyo DVD players, you can enter the pre- program code so that you can operate the DVD player directly

with the remote controller without connecting the terminals (see page 66).

29

Page 29
Image 29
Integra DTR-5.3 instruction manual Power on/ready function, Direct change function, Power off function