Intel 654655-001 manual IP Configuration, get-ip-conf, set-ip

C H A P T E R 2 Configuring and Managing the Switch

NOTE

If the IP configuration is not specified, the agent will not respond to any in-band re- quests, including ping mes- sages and network management applications.

IP Configuration

get-ip

Shows the switch’s current IP address:

SYS_console> get-ip

The device IP address is: 129.001.001.064

SYS_console> _

If the switch doesn’t have an IP address assigned:

SYS_console> get-ip

The device has no IP address defined.

get-ip-conf

Shows the complete current IP configuration: IP address, netmask (subnet mask), and broadcast address.

SYS_console> get-ip-conf

The device has no IP Address defined

SYS_console> get-ip-conf

The device IP address, netmask and broadcast are:

IP address		: 129.001.001.064
IP	netmask	: 255.255.000.000
IP	broadcast : 129.001.001.000

set-ip

set-ip <IPaddress>

Sets the IP address of the switch (technically, the switch’s SNMP agent). If no IP address was previously set (which is the default configuration), the new value is used immediately and saved in NVRAM. Otherwise, the new value is stored in NVRAM, but you must use the warm-resetcommand or cycle the power for changes to take effect.

Example:

set-ip 129.001.001.064
Device	IP	Address unchanged		for	this session
Device	IP	Address change in		the	NVRAM OK
The device NVRAM IP address				will be:
		IP address	: 129.001.001.064

31