Intel 654655-001 manual Port configuration commands, get-port-cfg, set-port-dplex

C H A P T E R 2 Configuring and Managing the Switch

Port configuration commands

This section contains instructions for configuring and displaying port settings with the Console Manager.

get-port-cfg

Displays the current port configuration.

SYS_console>get-port-cfg

PORT_ID LAN_TYPE LINK IF_TYPE PORTSEL FDPLX FCTRL

========================================================

1	NONE	---- PORT NOT INSTALLED ----
2	NONE	---- PORT NOT INSTALLED ----
3	ETH100X	OFF	TPFD	TP	OFF	ON
4	ETH100X	OFF	TPFD	TP	OFF	ON
5	ETH100X	OFF	TPFD	TP	OFF	ON
6	ETH100X	OFF	TPFD	TP	OFF	ON
7	ETH100X	OFF	TPFD	TP	OFF	ON

The command displays the following information for each port:

•LAN type: ETH100X indicates 100BASE-TX Fast Ethernet

•Link status: ON or OFF

•Physical interface type: TPFD indicates Twisted-pair (TP) Ethernet, Full Duplex (FD) capable

•Physical interface selected: TP for the Express Switching Hub

•Full duplex mode: ON or OFF (default)

•Flow control: ON or OFF. If you set a port to full duplex, flow control is automatically turned off (changes take effect after a reset). If you try to set flow control to ON while full duplex is selected, the Console Manager ignores the change on reset.

set-port-dplex

set-port-dplex <port_number> {halffull}

Specifies whether the given port is in full-duplex or half-duplex (standard Ethernet) mode. The default is half-duplex.

SYS_console> set-port-dplex 2 full

Port configured in <full_duplex> mode

Parameter change in NVRAM OK

49