Intel 654655-001 manual Quick Start, Console Mgmt

Quick Start

1.Install the Express 100BASE-TX Switching Hub in a rack or on a shelf or table, plug the cord in, and turn the power on. See page 5 (steps 1 and 2).

	Port 1			Port 2	Intel Express
					100BASE-TX Switching Hub
Port 3	Port 4	Port 5		Port 6	Port 7
					Console Mgmt SNMP Pwr
MDI	MDI	MDI	MDI	MDI	Mgmt Fault
		100BASE-TX

PC-3435

Brackets and screws for standard 19-inch equipment rack placement.

Rubber feet for shelf or table placement.

2. Connect the network devices to the switch. See page 5 (step 3) and pages 10–12.

	Port 1			Port 2	Intel Express
					100BASE-TX Switching Hub
Port 3	Port 4	Port 5	Port 6		Port 7
					Console Mgmt	SNMP Pwr
MDI	MDI	MDI	MDI		MDI	Mgmt Fault
		100BASE-TX
Straight-through					Crossover cables to
cables to hubs					servers/workstations

Intel Express

100BASE-TX hub

NOTES

•Connect only 100 Mbps devices to the switch. See page 12 for information on connecting to 10 Mbps segments.

•The default configuration for each port is half duplex mode only.

•Always use Category 5 cabling.

PC-3436

100BASE-TX server/

workstation

3. Check the LEDs for power and links. See pages 6 and 7.

Console Mgmt

SNMP Pwr

Mgmt Fault

Blinks every two seconds.

Should always be on.

Lights briefly while the switch performs self-tests.

Port 3

Xmt FC/FD Mgmt

Rcv Clsn Link

MDI

Lights when device is plugged into the port.

Next steps (Optional)

•Continue to the next page if you want to configure the switch to work with an SNMP-compliant Network Management System (NMS).

•See Chapter 2 if you want to use the Console Manager to change port configurations (set a port for full duplex), assign an IP address, or check port statistics.

1