56K V.92 Data, Fax, and Voice Chipset

4.ERROR CORRECTION AND DATA COMPRESSION

The MD566X chipsets support two types of data mode error correction (MNP2–4 and V.42) and data compression (V.44, MNP 5 and V.42 bis). V.42 error correction uses LAPM as the primary error-control protocol and uses MNP 2-4 as an alternative.V.44 provides enhanced data compression over the existing V.42bis standard. Data compression is up to on average 40% faster than previous methods. This provides for faster web browsing and data downloading. The +DS44 command configures the operation of V.44. There are nine parameters associated with the +DS44 command. For a detailed description of this command, refer to Table 4-2V.42 bis data compression requires V.42 (LAPM only). MNP 5 requires MNP 2-4.

The MD566X chipsets support four operating modes: buffer (normal), MNP reliable, V.42 auto- reliable, and V.42 reliable. These four modes are selected by the \Nn command. They allow the DCE to communicate with remote modems that may or may not support error correction and data compression. Speed buffering, which is used for all operating modes, allows the DTE-to-modem data rate to be different from the modem-to-modem data rate. This is accomplished by using transmitter and receiver buffers in the modem. Thus, the DTE-to-modem data rate can be set for 2400 bps when the modem-to-modem data rate is 300 bps without causing any data errors. In all data modes, the DTE-to-modem data rate can be set for any valid speed between 300 bps to 115,200 bps (that is, the modem autobauds up to 115,200 bps). The modem-to-modem data rates can be set to 300, 1200, 2400, 4800, 7200, 9600, 12,000, 14,400, 16,800, 19,200, 21,600, 24,000, 26,400, 28,800, 31,200, and 33,600 bps. Each operating mode is explained in more detail in the following tables.

When V.80 mode (synchronous access mode) for videoconferencing becomes available in the future, the +ES=m commands for data correction/compression will supersede the \Nn commands. Control reverts to the \Nn command upon exiting V.80 mode.

Operating Modes

Mode

Features

 

 

Buffer (Normal)

No error correction/data compression, but speed buffering is sup-

\N0 or \N1

ported.

 

 

MNP Reliable

MNP 2–5 connection only. If an MNP connection cannot be estab-

\N2

lished, the modem hangs up.

 

 

V.42 Auto-Reliable

V.42/V.42 bis with fallback to MNP 2–5 or normal mode.

\N3

 

 

 

V.42 Reliable

V.42, V.42 bis or MNP 2–5 only connection. If a V.42/V.42 bis/MNP 2–

\N4

5 connection cannot be established, the modem hangs up.

 

 

 

 

Programmer’s Guide

Intel Confidential

63

Page 63
Image 63
Intel MD566X manual Error Correction and Data Compression, Mode Features