Invacare 9000 XT, 9000 Series Rear Wheels, Section, Keep locking pins clean, Inside Of Wheelchair

REAR WHEELS SECTION 6

4. To reinstall the rear wheel onto the wheelchair, reverse STEPS 1-3.

NOTE: Make sure axle spacer is between rear wheel and wheelchair frame if wheelchair is equipped with conventional arms.

WARNING

Make sure the detent pin and locking pins of the quick-release axle are fully released BEFORE operating the wheelchair.

The locking pins MUST be protruding past the inside of the rear wheel axle bushing for a positive lock (DETAIL "A", FIGURE 3).

Keep locking pins clean.

Invacare recommends inserting quick-release axles with the detent pin to the inside of the wheelchair to prevent accidental release during contact activities.

5.If the locking pins are not protruding past the inside of the axle bushing or there is too much side to side movement of the rear wheel assembly, refer to ADJUSTING THE QUICK RELEASE AXLE in this section of the manual.

DETAIL "A" - LOCKING PINS AND DETENT PIN

REAR WHEELS

Axle Bushing

Locking Pins

INSIDE OF

WHEELCHAIR

OUTSIDE

OF

WHEELCHAIR

Detent Pin

Quick- Release Axle
Axle Mounting Positions	Wheelchair Frame
Axle Spacer (Conventional Arms Only)

Quick-Release Axle

Rear Wheel

FIGURE 1 - REMOVING/INSTALLING THE REAR WHEELS -

QUICK-RELEASE AXLES

Part No. 1056953 35 9000 Series