Invacare 9000XT Recliner, 9000 XT, 9000 Series manual Heel Loop Replacement Figure, Front Riggings

FRONT RIGGINGS

SECTION 3FRONT RIGGINGS

HEEL LOOP REPLACEMENT (FIGURE 4)

1.	Pull the cam lock lever UP to the	Mounting Screw
	UNLOCKED position.		Cam Lock Lever
2.	Push IN the release buttons and re-	Spacer
	move the lower footrest assembly.		Heel Loop
3.	Remove the mounting screw, spacer		Slide Tube
	and locknut that secure the heel loop
	to the footrest.		Lower
4.	Remove EXISTING heel loop from	Locknut	Footrest
	slide tube.		Assembly
5.	Install NEW heel loop onto slide tube.		Footrest
		FIGURE 4 - HEEL LOOP
6.	Install the mounting screw, spacer and
			REPLACEMENT
	locknut to secure the heel loop to the

footrest. Tighten until the spacer is secure.

7.Insert the lower footrest assembly into the upper footrest assembly to desired height.

8.Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support.

9.Rotate cam lock lever DOWN to LOCKED position.

9000 Series 26 Part No. 1056953