Invacare 9000 SL Removing/Installing The Rear Wheels, Permanent Axles, Quick-Release Axles Figure

WHEELSREAR

SECTION 6 REAR WHEELS

Section 6 - Rear Wheels includes the following:

Removing/Installing the Rear Wheels

Replacing Rear Wheel Handrim

Replacing/Repairing Rear Wheel Tire/Tube

Adjusting the Quick-Release Axle

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.

NOTE: The procedures in this section apply to NON-RECLINER models only EXCEPT where noted. For RECLINER models, refer to SECTION 9 of this manual.

REMOVING/INSTALLING THE REAR WHEELS

WARNING

If changing the size of the rear wheel or a change in the SEAT-TO- FLOOR HEIGHT is desired, this procedure MUST be performed by a qualified technician.

PERMANENT AXLES

WARNING

If the wheelchair is equipped with permanent axles, removal/installation of the rear wheels must be performed by a qualified technician.

QUICK-RELEASE AXLES (FIGURE 1)

WARNING

NEVER use quick-release axles on the 9000 XT (models with offset axle option ONLY), 9000XDT or 9000XT RECLINER wheelchairs.

NOTE: If replacing the same size rear wheel, note the mounting position on the wheelchair frame for proper reinstallation of the NEW rear wheel.

1.Push in the detent pin of the quick-release axle (with wheel) and pull the axle out through the opening in the center of the rear wheel and axle spacer.

NOTE: Axle spacer is used only if wheelchair is equipped with conventional arms.

2.Push in the detent pin of the quick-release axle again and pull the axle out of the rear wheel.

3.Repeat STEPS 1-2 for the opposite rear wheel.

9000 Series 34 Part No. 1056953