Invacare 9000XT Recliner Installing The Amputee Bracket - Super Hemi Models Only Figure, Section

Models: 9000 XDT 9000 Series

1 60
Download 60 pages 56.17 Kb
Page 56
Image 56
FIGURE 3 - INSTALLING THE CRUTCH AND CANE CARRIER

SECTION 10

OPTIONS

 

 

 

1.Slide the clamp with the base attached over the end of the step tube of the wheelchair. Ensure the base is towards the inside of the

wheelchair.

OPTIONS

2. Position the base parallel to the step tube.

CAUTION

Base should be parallel to step tube to avoid bending spokes when folding the wheelchair.

3.Securely tighten the locknut that secures the base to the step tube of the wheelchair.

4.Remove the upper back upholstery screw and washer.

5.Align the strap with the back upholstery screw mounting hole.

Strap

Base

Step

TubeClamp

Locknut

FIGURE 3 - INSTALLING THE CRUTCH AND CANE CARRIER

6.Reinstall the back upholstery screw and washer and secure the strap to the wheelchair.

7.The base cleans easily with any chrome or glass cleaner. The strap can be cleaned with mild soap and water.

INSTALLING THE AMPUTEE BRACKET - SUPER HEMI MODELS ONLY (FIGURE 4)

1.Remove the plug button or anti-tipper from the step tube of the wheelchair frame.

2.Slide the amputee attachment over the step tube of the wheelchair.

3.Secure the amputee attachment to the wheelchair with the hew screw, spacer and locknut.

4.Reinstall the plug button or anti-tipper onto the step tube of the wheelchair frame.

5.Repeat STEPS 1-4 for the opposite side of the wheelchair.

6.Reposition the rear wheels. Refer to

REMOVING/INSTALLING REAR WHEELS in SECTION 6 of this manual.

 

Wheelchair

Spacer

Frame

 

Locknut

Step

Tube

Hex Screw

Amputee Attachment

FIGURE 4 - INSTALLING THE AMPUTEE BRACKET - SUPER HEMI MODELS ONLY

9000 Series

56

Part No. 1056953

Page 56
Image 56
Invacare 9000XT Recliner, 9000 XT Installing The Amputee Bracket - Super Hemi Models Only Figure, Section, Options, Spacer