SECTION 9 | RECLINER | |
|
|
|
INSTALLING THE TELESCOPING I.V. ROD
INSTALLING THE TELESCOPING I.V. ROD HOLDER (FIGURE 12)
RECLINER
1.Remove the rear wheel from the wheelchair. Refer to REMOVING/ INSTALLING THE REAR WHEELS in this section of the manual.
2.Remove the locknut and hex screw that secure the arm socket to the wheelchair frame.
3.Remove the locknut that secures the back tube to the clevis bracket.
4.Position the top hole on the flat portion of the I.V. holder on the exisitng pivot screw of the clevis bracket as shown in FIGURE 13.
5.Reinstall locknut onto pivot screw. DO NOT tighten yet.
6.Thread the provided mounting screw through the lower hole on the front cylinder section of the I.V. holder, through the side frame, and into the locknut. Turn nut until snug fit is obtained. DO NOT tighten yet.
7.Reinstall the arm to orient front cylinder of I.V. holder. Refer to RE- MOVING/REPLACING ARMRESTS in SECTION 4 of this manual.
8.Once front cylinder is oriented for proper clearance of the armrest, securely tighten both locknuts.
STEP 2
Arm Socket (OUT-
SIDE of WheelchairHex Screw
Frame)
Locknut
Outside of
Wheelchair
Frame
Locknut (STEP 6) | Back Tube | |
| (STEP 3) | |
| Clevis | |
I.V. Holder (STEP 4) | Bracket | |
(STEP 3) | ||
| ||
Mounting | Pivot Screw | |
Screw | ||
(STEP 6) | (STEP 4) |
Locknut
(STEPS 3 and 5 )
FIGURE 12 - INSTALLING THE TELESCOPING I.V. ROD HOLDER
9.Install the I. V. rod support tube. Refer to INSTALLING THE I.V. ROD SUPPORT TUBE in this section of the manual.
9000 Series | 52 | Part No. 1056953 |
