Invacare 9000 SL, 9000 XT, 9000 XDT Installing The Anti-Tippers Figure, Section, Xt Recliner

RECLINER SECTION 9

INSTALLING THE ANTI-TIPPERS (FIGURE 15)

1.Install the anti-rattles onto the rear frame tubes if not already in place.

2.Position the anti-tippers with the anti- tipper wheels pointing toward the ground/floor

3.Press the release buttons IN.

4.Insert the anti-tippers into the rear frame tubing until the bottom release button locks in place.

Release Buttons	Rear
	Frame
	Tubing

Anti-tipper

Wheels

Anti-tipper

Anti-Rattle

FIGURE 15 - INSTALLING THE

ANTI-TIPPERS

RECLINER

NOTE: Refer to the following charts to ensure the correct anti-tipper is installed in the wheelchair. Seat-to-Floor heights are approximate depending on front caster type.The anti-tipper height mea- surement MUST be taken with the anti-tipper on a flat surface.

Anti-Tipper	Flat Surface
Height

Anti-Tipper Length

9000 XT RECLINER

WHEEL SIZE	SEAT-TO-FLOOR	ANTI-TIPPER	ON CHAIR	OFF CHAIR
REAR/CASTER	HEIGHT	LENGTH, HEIGHT		KIT NUMBER
24/8-inch	19-1/2-inches	11-1/2, 2-1/2-inches	1021767	1021767
22/8-inch	18-1/2-inches	10-1/4, 1-7/8-inches	1061110	1061110
20/8-inch	17-1/2-inches	10, 1-1/2-inches	1061109	1061109

Part No. 1056953 49 9000 Series