Juniper Networks manual NetScreen-5200 Front and Rear Mount, Mounting the NETSCREEN-5000 Series

Mounting the NetScreen-5000 Series

There are two ways to rack mount the NetScreen-5200:

•Rear and front mount

•Mid-mount

Note: Juniper Networks strongly recommends the rear and front rack mount configuration for the NetScreen-5200.

You can only front-mount the NetScreen-5400.

MOUNTING THE NETSCREEN-5000 SERIES

The following sections describe how to rack mount the NetScreen-5000 Series.

•NetScreen-5200 Front and Rear Mount

•NetScreen-5200Mid-Mount

•NetScreen-5400 Front Mount

NetScreen-5200 Front and Rear Mount

To mount the NetScreen-5200 with support from the front and rear, you need four fitted screws, a Phillips-head screwdriver, the rear slide kit, and brackets.

To mount the NetScreen-5200:

1.Screw the rear mount bracket to the rear rack posts.

2.With the indented groove of each slide facing outward, screw the slides to the middle of each side of the chassis.

3.Slip the slides into the rear mount brackets, then push the NetScreen-5200 forward until the left and right brackets contact the front rack posts, as shown below.

4.Screw the left and right brackets to the rack.

NetScreen-5000 Series 15