JVC 1105RYMMDWJEIN manual Changing the transmittable signals for operating a VCR, Release VCR

❏Changing the transmittable signals for operating a VCR

1Press and hold VCR .

2Press VCR.

3Enter the manufacturer’s code using buttons 1 – 9, and 0.

See “Manufacturers’ codes for VCR” on the right.

4Release VCR .

Now, you can perform the following operation on the VCR.

VCR :Turn on or off the VCR.

After pressing VCR, you can perform the following operations on the VCR.

CHANNEL +/–:	Change the channel numbers on the
	VCR.
1 – 10, 0, +10:	Select the channel numbers on the VCR.
3:	Start playback.
7:	Stop playback.
8:	Pause playback.
FF:	Fast-wind a tape.
REW:	Rewind a tape.
+ 3:	Start recording.

See the instructions supplied with the VCR for details.

5Try to operate your VCR by pressing VCR .

When your VCR turns on or off, you have entered the correct

code.

If more than one code is listed for your brand of VCR, try each

one until the correct one is entered.

Manufacturers’ codes for VCR

Manufacturer	Codes
JVC	01
Akai	02, 36
Bell+Howell	03, 16
Blaupankt	04
CGM	03, 05, 16
Daewoo	34
DIGITAL	05
Fisher	03, 16
G.E.	06
Grundig	07
Hitachi	08, 09
Loewe	05, 10, 11
Magnavox	04, 05
Mitsubishi	12, 13, 14, 15
Nokia	16
Nordmende	17, 18, 19, 31
Orion	20
Panasonic	21
Philips	05, 22
Phonola	05
Saba	17, 18, 19, 23, 31
Samsung	24, 25
Sanyo	03, 16
Sharp	26, 27
Siemens	07
Sony	28, 29, 30, 35
Telefunken	17, 18, 19, 31, 32
Toshiba	33

Initial setting: 01

Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

54