⁄Speakers
To connect the speaker cords
Press and hold | Insert | Release |
•When connecting the speaker cords, match their polarity with that of the speaker terminals: blue/red to (+) and black to
For CA-DXJ30
From right subwoofer (red/black)
From left subwoofer (red/black)
From front left speaker (blue/black)
From front right speaker (blue/black)
•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the System.
•The front speakers and subwoofer(s) are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.
–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.
Then wait at least 30 minutes before turning on the TV’s main power switch again.
Some TVs may still be affected even though you have followed the above instruction. If this happens, move the speakers away from the TV.
•DO NOT connect more than one speaker to each terminal.
• DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.
@Auxiliary equipment
Red
Stereo audio cord (not supplied)
White
For CA-DXJ20
From subwoofer (red/black)
From front right speaker (blue/black)
From front left speaker (blue/black)
For CA-DXJ10
From front left speaker (red/black)
From front right speaker (red/black)
¤Voltage selector
(not applicable for Australian models)
Use a screwdriver to rotate the voltage selector so that the voltage mark is pointing to the same voltage as where you are plugging in the unit. (See also the back cover page.)
Voltage mark
#Power cord
Plug the AC power cord to a wall outlet.
DO NOT plug in before setting the voltage selector and all connection procedures are completed.
5
