JVC GR-DV1 manual Audio Dubbing

59

Audio Dubbing

Using a tape recorded at 32 kHz, you can customize the soundtrack of a tape you’ve recorded.

NOTE:

Audio Dubbing is not possible on a tape recorded at 48 kHz.

EXT. MIC INPUT	POWER DIAL
CONNECTOR

	REMOTE SENSOR
T W	AUDIO MONITOR
DISPLAY BUTTON	BUTTON
6e	A.DUB BUTTON
	PLAY BUTTON
STOP BUTTON	PAUSE BUTTON

AUDIO DUB STANDBY

1 FIND EDIT-IN POINT

Play back the tape to locate the point where editing will start, then press PAUSE.

2 CONNECT EXTERNAL MICROPHONE

Connect an optional stereo microphone. Then while holding A. DUB on the remote control, press PAUSE.

•Pull out the viewfinder and “6e” appears. •Press DISPLAY on the remote control if

sending the image to a connected TV.

3 BEGIN DUBBING

Press PLAY, then begin “narrating” using the external microphone.

RM-V708U (provided)

4 PAUSE DURING DUBBING

Press PAUSE.

5 STOP DUBBING

Press STOP.

NOTES:

●When editing onto a tape that was recorded at 32 kHz, the old and new soundtracks are recorded separately.

●To select the desired sound for playback, press AUDIO MONITOR on the remote control.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If you change from 32 kHz to 48 kHz in mid- recording and then use the tape for Audio Dubbing, it is not effective from the point where 48 kHz recording began.

RECORDING SOUND	DISPLAY		OUTPUT SOUND
32 kHz	FULL SOUND	Original and new tracks are combined and output in stereo.
	SOUND 1	Original track is output on both "L" and "R" channels in stereo.
	SOUND 2	New track is output on both "L" and "R" channels in stereo.