Playback images on the camera recorder can be stream output during editing using a
1 Perform the following settings on the camera recorder.
ASet the [HD/DV] IEEE1394 terminal mode switch to ADVB.
BSet the [INT/EXT] IEEE1394 interface terminal switch to
AEXTB.
Memo :
●Stream transmission is only possible for DV format images.
2 Connect the IEEE1394 cable.
3 Turn on the power of both the camera recorder and
4 Set the camera recorder to Media mode.
Press the [CAM/MEDIA] selection button to switch to Media mode. (A Page 7)
7 Start loading to the
For details, refer to the instruction manual of the
8 Loading is complete.
After loading is complete, press the [CANCEL] button on the camera recorder to stop playback.
Memo :
●Switch the [HD/DV] IEEE1394 terminal mode switch only after turning OFF the power of the camera recorder.
●The operating procedures vary depending on the characteristics and specifications of the connected devices, and transfer of data may fail even when the devices are properly connected.
●If noise appears on the screen or audio sound is interrupted, reconnect the IEEE1394 cable or turn on the power of the camera recorder again.
●Noise may occur in the audio when you turn ON/OFF the power of the device connected to the [IEEE1394] terminal. Before performing any of these operations, lower the volume of the device connected to the camera recorder to the minimum.
[IEEE1394] Terminal
[HD/DV] IEEE 1394 |
| PC |
| ||
| ||
Terminal Mode |
| |
|
| |
Switch |
|
|
[INT/EXT] IEEE1394
Interface Terminal
Switch
Note :
IEEE1394
Cable
Signal Flow
●Start recording only after ensuring that the devices are properly connected.
5 Insert the media to be dubbed.
Camera recorder : Recorded SDHC card
6 Press the play button (center of the
Playback starts.
113