2 Set the time code (hour, minute, second, frame).

Use the cross-shaped button (H, I) to place the cursor at the item to set, then the cross-shaped button (J, K) to change the values.

Memo :

●Press the [USER2] button to reset each digit to A0B. The cursor moves to the time digit (left).

3 Check the values and press the cross-shaped button (R).

●The time code is set and the screen returns to the normal screen.

●To cancel the setting, press the [CANCEL] button.

Note :

●Editing will be canceled and the screen will close under the following situations.

●The [TC DISPLAY] switch is selected during editing.

●The camera recorder is switched to the Media mode.

●When editing time code, operations of the [USER1], [USER2], [USER3] buttons that are set in the [Main Menu]B[Camera Function]B[Switch Set...] menu are disabled. [USER2] functions as the number reset button. (A Page 74)

Setting User’s Bit Without Opening the Menu

Memo :

●Settings cannot be made in the following cases.

●[TC GENE.] switch is set to AREGENB.

●Menu screen is displayed.

●The camera recorder is not in Camera mode.

Required Settings Before Preset (A Page 47)

●Set the [TC DISPLAY] switch to AUBB.

●Set the [TC GENE.] switch to settings other than

AREGENB.

Setting User’s Bit

1 Hold down the [MENU] button and press the [USER1] button.

The [UB Preset] setting screen appears.

Cursor

[UB Preset] Screen

2 Set the user’s bit.

Use the cross-shaped button (H, I) to place the cursor at the item to set, then the cross-shaped button (J, K) to change the values.

Memo :

●Press the [USER2] button to reset each digit to A0B. The cursor moves to the left.

3 Check the values and press the cross-shaped button (R).

●The user’s bit is set and the screen returns to the normal screen.

●To cancel the setting, press the [CANCEL] button.

Note :

●Editing will be canceled and the screen will close under the following situations.

●The [TC DISPLAY] switch is selected during editing.

●The camera recorder is switched to the Media mode.

●When editing time code, operations of the [USER1], [USER2], [USER3] buttons that are set in the [Main Menu]B[Camera Function]B[Switch Set...] menu are disabled. [USER2] functions as the number reset button. (A Page 74)

Recording Time Code in Continuation of the Recorded Time Code on SDHC card

[TC GENE.] Setting Switch

This camera recorder is equipped with the time code reader. Set the [TC GENE.] switch on the inner panel of the LCD to

AREGENB.

When the camera recorder enters from recording standby mode to recording mode, it reads the time code already recorded on the SDHC card and records the new time code in continuation of that value.

The same data as the user’s bit already recorded on the SDHC card is recorded.

Memo :

●When the [TC GENE.] switch is set to AREGENB, the framing mode of the time code follows the settings in [Drop] of the [TC/UB] menu instead of the clip settings. (A Page 82)

49