12 EN | INSTALLING YOUR NEW RECORDER |
Basic Connection
Aerial connector
Back of TV
TV aerial cable
RF cable | ||
cable | ||
(provided) | ||
(provided) | ||
| ||
AV1 | Mains power cord | |
IN/OUT | ||
|
It’s essential that your video recorder be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
A Check the contents.
Make sure the package contains all of the accessories listed in “SPECIFICATIONS” on page 98.
B Situate the recorder.
Place the recorder on a stable, horizontal surface.
C Connect the recorder to TV.
ADisconnect the TV aerial cable from the TV.
BConnect the TV aerial cable to the ANTENNA IN connector on the rear panel of the recorder.
CConnect the provided RF cable between the ANTENNA OUT connector on the rear panel of the recorder and the TV’s aerial connector.
DConnect the provided
the recorder and the TV’s
● The AV1 |
composite signal (regular video signal) or a Y/C signal (a signal |
in which the luminance and chrominance signals are |
separated). If your TV’s |
compatible with the Y/C signal, set |
completed ( pg. 64). You can obtain |
pictures. (For connection, be sure to use a |
that is compatible with the Y/C signal.) |
● Set your TV to the VIDEO (or AV), Y/C, or RGB mode |
according to the type of your TV’s SCART connector. |
ANTENNA ANTENNA
IN OUT
Back of recorder
● For switching the TV’s mode, refer to the instruction manual of |
your television. |
Mains outlet
ATTENTION:
Your TV must have a
● To obtain |
D Connect the recorder to mains.
Plug the end of the mains power cord into a mains outlet.
After the connection is completed, perform “Auto Set Up” on page 14.