JVC HM-HDS1EU 8 B.E.S.T, Picture Control, DIGITAL 3R, Digital Tbc/Nr, Vcr Set Up, Auto

EN 77

VCR SET UP 2

* The default setting is bold in the table below.

8 B.E.S.T.	You can set the B.E.S.T. (Biconditional Equalised Signal Tracking) system to
ON	“ON” or “OFF” ( pg. 41).
OFF
8 PICTURE CONTROL	This feature helps you to adjust the playback picture quality according to your
AUTO	preference. Normally select “AUTO”.
EDIT	AUTO:	Provides the optimised picture benefits of the B.E.S.T. Picture
SOFT		System.
SHARP	EDIT:	Minimizes picture degradation during editing (recording and
	SOFT:	playback).
		Reduces image coarseness when viewing overplayed tapes
	SHARP:	containing a lot of noise.
		Clearer, sharper-edged picture when viewing images with lots
		of flat, same-coloured surfaces such as cartoons.
	NOTES:
	● When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until
	you select another mode.
	● When you select “EDIT” to dub tapes, be sure to select “AUTO” after you finish
	dubbing the tapes.
	● When “B.E.S.T.” is “OFF”, “PICTURE CONTROL” switches automatically from “AUTO”
	to “NORM”.
8 DIGITAL 3R	When this function is set to “ON”, the Digital 3R picture system applies edge
ON	correction to the luminance signal to enhance detail.
OFF	NOTES:
	● Normally it is recommended to keep “DIGITAL 3R” set to “ON”.
	● Depending on the type of tape being used, picture quality may be better with “DIGITAL
	3R” set to “OFF”.
	● If you use the recorder as the source player for editing, be sure to set “DIGITAL 3R” to
	“OFF” before starting.
8 DIGITAL TBC/NR	Your recorder is equipped with the Digital TBC (Time Base Corrector) that
ON	removes jitter from fluctuating video signals to deliver a stable picture even with
OFF	old tapes and rental cassettes.
	The on/off of Digital 3-DNR (Noise Reduction) which cuts noise and enables
	clear picture reproduction is also linked to this function.
	We recommend that you set “DIGITAL TBC/NR” to “ON” when...
	... playing back a tape recorded on a camcorder.
	... playing back a tape repeatedly used.
	... using this video recorder as the source player for editing.
	NOTES:
	● If you play back a tape recorded under poor TV reception condition, the picture may
	become more stable with Digital TBC/NR set to off.
	● When “DIGITAL TBC/NR” is set to “ON”, if you play back a tape where certain types of
	signals are recorded (using a PC or some character generators), the playback picture
	may be distorted. If this is the case, set “DIGITAL TBC/NR” to “OFF”.
	● When playing back a MESECAM tape, Digital TBC/NR does not function even though
	“DIGITAL TBC/NR” is set to “ON”.