| |
Installation/Connection Manual |
|
| |
1205DTSMDTJEIN | |
[UT] | EN, CT |
| © 2005 Victor Company of Japan, Limited |
ENGLISH | |
This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does | 12 V |
not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers. | JVC |
WARNINGS
To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all electrical connections before installing the unit.
• Be sure to ground this unit to the car’s chassis again after installation.
Notes:
•Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealers.
•It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than
50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 14 of the
INSTRUCTIONS).
•To prevent
•The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
Heat sink
|
|
|
|
| |
! |
|
|
|
|
|
|
| JVC |
|
| |
| 50 W | 4 Ω - 8 Ω |
|
| |
50 W | “AMP GAIN” |
| 18 | ||
|
|
|
|
| |
|
|
|
|
|
PRECAUTIONS on power supply and speaker connections: | ! |
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit | |
will be seriously damaged. |
•BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.
Parts list for installation and connectionThe following parts are provided for this unit. If any item is missing, consult your JVC car audio dealer | 0<) |
immediately. |
|
A / B | C | D |
Hard case/Control panel | Sleeve | Trim plate |
|
|
E | F | G | H |
Power cord | Washer (ø5) | Lock nut (M5) | Mounting bolt (M5 ⋅ 20 mm) |
| (ø5) | (M5) | (M5 ⋅ 20 mm) |
I | J | K | L |
Rubber cushion | Handles | Remote controller | Battery |
1