Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
The display does not light up. | The power cord is not plugged in. | Plug the power cord into an AC outlet. |
The buttons and controls on the front panel do not work.
The
•Press MAIN ROOM ON/OFF for the main room operations.
•Press SUB ROOM ON/OFF and SUB ROOM CONTROL for the
No sound from the speakers in the main room.
Speaker signal cables are not connected | Check speaker wiring and reconnect if |
properly. | necessary. |
|
|
The SPEAKERS 1 (MAIN ROOM) and | Press SPEAKERS 1 (MAIN ROOM) and |
SPEAKERS 2 (SUB ROOM) buttons are | SPEAKERS 2 (SUB ROOM) correctly. |
not set correctly. |
|
An incorrect source is selected for the main room.
Select the correct main room source.
Muting is activated for the main room source.
Press MUTING to cancel the mute.
No sound from the front speakers in the
Speaker signal cables are not connected | Check speaker connection and reconnect if |
properly. | necessary. (See page 11.) |
|
|
Main/sub setting for the speakers | Set the main/sub setting for the speakers |
connected to the FRONT 2/SUB ROOM | correctly to use them as the |
terminals are not set correctly. | speakers. (See page 23.) |
|
|
Amplifier connected to the SUB ROOM | Turn on the amplifier. |
PRE OUT is not turned on. |
|
|
|
An incorrect source is selected for the | Select the correct |
| |
|
|
Muting is activated for the
Press MUTING to cancel the mute.
Sound from one speaker only in the main room.
The balance is set to one extreme. | Adjust the balance properly (see page 19). |
The SUB ROOM ON/OFF button does not work.
Surround is used for the main room. | Cancel the Surround in the main room. |
Surround cannot be used for the main room sources.
Deactivating the
CD tracks are skipped, tape is rewound, or radio station is changed unintentionally.
When the same source is selected both for the main room and the
This is normal, not the malfunction of the unit. Selecting different sources for the main room and the
The receiver does not work correctly as you operate it.
Main room and
If this happens, perform the same operation again.
Continued to the next page.
63