AM Antenna Connections
|
|
| Snap the tabs on the loop into the |
ANTENNA | slots of the base to assemble the | ||
FM 75 | AM loop. | ||
COAXIAL |
| ||
|
|
|
|
AM
LOOP
AM Loop Antenna
AM
EXT
123
Outdoor single
Turn the loop until you have the best reception.
Notes:
•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.
•If reception is poor, connect an outdoor single
Connecting the Speakers
You can connect the following speakers:
•Two pairs of front speakers to produce normal stereo sound.
•One pair of rear speakers to enjoy the surround effect.
•One center speaker to produce more effective surround effect (to emphasize human voices).
•One powered subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker setting information properly:
•To obtain the best possible DSP effect in the main room, see page 24.
•To use the
For each speaker (except for a subwoofer), connect the
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Basic connecting procedure
1 | 2 | 3 |
| 4 |
|
| 1 | 1 |
| 1 |
|
| RI | RIG |
| RIG |
|
| GH | HT | HT | ||
| T |
|
|
1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).
2Turn the knob counterclockwise.
3Insert the speaker signal cable.
4Turn the knob clockwise.
Connecting the front speakers
You can connect two pairs of front speakers — one pair to the FRONT 1 SPEAKERS terminals, and the other pair to the FRONT 2/ SUB ROOM SPEAKERS terminals.
The speakers connected to the FRONT 2 / SUB ROOM SPEAKERS terminals can be used as follows:
•As the second front speakers in the main listening room
•As the main speakers in the sub listening room when using the
Right speaker |
| FRONT 1 SPEAKERS |
| Left speaker |
|
|
|
| FRONT 1 SPEAKERS |
|
|
|
| |
|
|
|
|
|
| CAUTION : |
|
+ | RIGHT | – | – | LEFT | + | SPEAKER IMPEDANCE | |
|
| 4 ~ 6 | LOW | ||||
|
|
|
|
|
| 8 ~ 16 | HIGH |
|
|
|
|
|
| SPEAKER | |
|
|
|
|
|
| LOAD |
|
+ RIGHT | – | – LEFT | + | SELECTOR |
CAUTION : SPEAKER IMPEDANCE 8 ~ 16
FRONT 2 / SUB ROOM SPEAKERS
Right speaker |
| FRONT 2 / SUB ROOM |
| Left speaker |
|
| |||
|
| SPEAKERS |
|
|
IMPORTANT for FRONT 1 SPEAKERS connection:
To obtain the best possible output power from the receiver, and to prevent the receiver from being overheated, the receiver has the SPEAKER LOAD SELECTOR which has to be set as follows:
•Set it to the HIGH position when the impedance of the front speakers connected is within the range of 8 Ω to 16 Ω.
•Set it to the LOW position when the impedance of the front
speakers connected is within the range of 4 Ω to 6 Ω.
5