JVC SR-VD400E manual 16 EN, Load a D-VHS cassette, Rew Ff, D-VHS indicator lights up

16 EN PLAYBACK (cont.)

PRO HD System Playback

●Turn on the VCR and the TV, and select the AV mode on the TV.

●Set the [VCR/TV/CABLE/DBS] selector on the Remote to [VCR].

[POWER] 1	[STOP/EJECT	2
	(7/0)]

IN F-1

+

[REW ()] [FF ()]

This PRO HD system can perform playback of the D-VHS tape recorded by the MPEG2-TS signal.

This VCR can check the tape condition during playback (and recording), and realizes the best possible pictures.

Please refer to next page, when you playback the tape on which the password was set up.

1 Load a D-VHS cassette

Make sure the window side is up, the rear label side is facing you and the arrow on the front of the cassette is pointing towards the VCR.

Do not apply too much pressure when inserting.

●The VCR turns on automatically.

●The tape will run for a few seconds while the VCR searches for the tape number. If the tape number is found, it will be shown on the TV screen if “SUPERIMPOSE” is set to “ON” ( page 39).

●The counter is reset automatically, however, it is not completely reset to “0:00:00”.

●If the cassette’s record safety tab has been removed, playback begins automatically.

●The [D-VHS] indicator lights up.

[POWER]

VCR CABLE

TV /DBS

2

[REW(1)] [FF(¡)]

[STOP(7)]

2Start playback

Press [PLAY ( 3 )].

●Tape speed is automatically detected.

To stop playback

Press [STOP ( 7 )] on the Remote or [STOP/EJECT ( 7/0 )] on the front panel.

To rewind the tape (when it is not running)

Press [REW ( 1 )].

To fast-forward (when it is not running)

Press [FF ( ¡ )].

To eject the tape

Press [STOP/EJECT ( 7/0 )] on the front panel when the tape is not running.

●You can also eject the cassette when the VCR is turned off.

To turn off the VCR

Press [POWER].