JVC SR-VD400E manual 50 EN

50 EN TROUBLESHOOTING (cont.)

The following conditions are product features and do not indicate mechanical problems.

Playback of tapes recorded in D-VHS mode

¥You may see a mosaic (block) noise, grayed images, or a still image in cases of excessive distortion caused when playing back a damaged tape or when the heads are momentarily dirty.

¥After you press [PLAY (3)], it takes a moment until you see the image and hear the sound.

¥After you switch playback speeds (when switching from special effect playback to normal playback, for example), it takes a moment until you see the image and hear the sound. For a few seconds, the image may be played back out of sync with the sound.

Searching images on D-VHS tapes

¥The images appear frame by frame.

¥Block noise may appear on the bottom half of images.

¥When the blank portion is reached, a still scene of the last recorded image is displayed.

The picture stops/There is no sound

¥When two or more devices are connected to this VCR with the i.LINK cable (a camcorder and another i.LINK-compatible device), do not turn on the camcorder if you record a program from an another i.Link-compatible device. Turning on and off the camcorder may cause momentary still images and loss of sound.

Image or sound is distorted

¥When recording from a camcorder connected to this VCR with the i.LINK cable, the image or sound may be distorted. If this occurs, insert a D-VHS cassette in the VCR and turn off and on the VCR, then start recording again. If the problem is not fixed, record using the audio/video input connectors instead of i.LINK connector.

Recording from camcorders and other devices via i.LINK connector

¥You may see a mosaic (block) noise.

¥For scenes with fast action, the image may jitter. This does not affect recording, which will proceed as usual.

¥When you watch the camcorderÕs search images through this VCR, the block noise may appear.

¥When you record audio-dubbed DVC cassettes (tapes which have four recorded channels), sound may not be heard for the first few seconds.

¥When you eject and insert D-VHS cassettes, the sound may be interrupted for an instant.

¥When you press [REC SPEED]/[SPEED] to switch recording speed, the sound may be interrupted for an instant.

Incorrect image formatting for wide TVs

¥If you have connected two different devices using the S-video output connectors on the back of the VCR, the sensing signal for wide TVs may not be output correctly depending on the connected devices. If this occurs, use the TV controls to switch the screen size.