JVC SR-VD400E manual TV Brand, Setting, Turn on the TV, Set TV brand code, Operate TV

MULTI-BRAND REMOTE CONTROL					EN 45
TV Brand			When programmed (set) with a manufacturer’s (brand’s)
			code, this Remote can perform some of the remote control
			functions of the listed TVs. You can control a JVC TV without
Setting			setting a brand code.
			1 Turn on the TV
				Turn on the TV using the [POWER] button on the
				TV or its Remote.
2	3 - 1,3			Set remote operation mode
			2 Set the [VCR/TV/CABLE/DBS] selector to [TV].
	4		3	Set TV brand code
VCR CABLE	[TV/VCR]
TV /DBS				Follow the example shown below.
				1 Press and hold [POWER].
	4			2 Press the ‘Number’ keys to enter your TV’s
				brand code by referring to the table below.
				3 Press [STOP ( 7 )], and release [POWER].
3 - 2 4				● Once you have set the Remote to operate the
				TV, you do not have to set it until you replace
‘Number’ keys	[ENTER]			the batteries from the Remote.
				● JVC and PANASONIC have two codes. If the TV
				does not function with one code, try entering
				the other.
	3 - 3		4 Operate TV
				Press one of the following buttons: [POWER],
				[TV/VCR], [TV/VCR CH +/–], [	] (TV
	[TV VOL			Muting), [TV VOL +/–], and ‘Number’ keys.
	+/–]			● For some brands, you must press [ENTER] after
	[	]		having pressed the ‘Number’ keys to enter a
				channel number.
				● To operate the VCR, set the [VCR/TV/CABLE/
				DBS] selector back to [VCR].

TV BRAND NAME	BRAND CODE
JVC	01, 03
HITACHI	10
MAGNAVOX	02
MITSUBISHI	03
PANASONIC	04, 11
RCA	05
SHARP	06
SONY	07
SAMSUNG	12
SANYO	13
SEARS	13
TOSHIBA	08
ZENITH	09

NOTES:

●Depending on the type of TV, some or all functions cannot be operated using this Remote.

●It‘s impossible to control a TV that does not have a remote sensor.

(Ex.) To set Remote to RCA 05:

POWER	AUX	STOP
		JKL

Hold	Press in succession	Release
down