JVC SR-VD400E manual Set recording speed, Start recording, About Recording Speed, Std

EN 19

5 Set recording speed

Press [REC SPEED]/[SPEED] to set the recording speed.

●The recording speed changes each time [REC SPEED]/[SPEED] is pressed.

6Start playback

Press [PLAY ( 3 )] on the connected device.

NOTE:

If the connected device is equipped with a superimpose/OSD disable feature then set it to “OFF” before starting playback.

	“AUTO” : When recording in HS or STD mode
		is selected automatically according to			Start recording
		the amount of data input (transfer		7 On the front panel:
		rate) of the program.			Press [REC ( ¶ )].
	“HS”	: When picture quality and sound
					On the Remote:
		quality is important.
	“STD”	: When picture quality and recording			While holding [REC ( ¶ )], press [PLAY ( 3 )].
		time are important.
					NOTE:
	“LS3”	: To record for three times longer than
		in STD mode, with picture quality			If “108 REC BY HS MODE” appears on the TV screen,
		that is equal to or better than S-VHS.		refer to ‘Error Codes and Messages’ on page 51.
	“LS5”	: When recording time is important.
		To record for five times longer than in
		STD mode.			Do not connect this VCR to the PC with the
	For more details, refer to ‘About Recording				i.LINK cable. The operation is not guaranteed.
	Speed’ below.
About Recording Speed
	Input Source		Selectable Recording Speed
	(Playback device)		(Recording device: This VCR)
		D-VHS	Auto (HS/STD/LS3/LS5)*, HS, STD, LS3, LS5
	i.Link input	Digital HD camcorder (MPEG2)	Auto (HS/STD)*, HS
		Digital HD camcorder (DV format)	HS, STD, LS3, LS5

* Auto mode: The recording speed will be selected automatically according to the amount of data input (the transfer rate) from the i.LINK connector.

NOTES:

● When dubbing using the i.LINK connector, set the recording speed on the recording VCR to the same speed as the source tape on the playback VCR.

● When “AUTO” is selected for the recording speed, “AUTO” and the selected speed appear on the front display panel in turn.