Audio settings Audio Function, Òstandardó | JVC SR-VD400E specification

EN 37

Audio settings “AUDIO FUNCTION”

* The default setting is bold in the table below.

“STD AUDIO REC MODE” You can select the audio format when you record a program or analog signal from

ÒSTANDARDÓ	connected devices in STD mode. When this function is set to ÒPCM&STANDARDÓ,
“PCM&STANDARD”	you can obtain high-quality audio sound.
	ÒSTANDARDÓ	: Select this when the picture quality is important and when
		you record in MP2 format.
	“PCM&STANDARD” : Select this when the sound quality is important.
		When you record the analog signals or DV signals from
		the camcorder in STD mode, PCM audio is also recorded
		in addition to MP2 audio. In HS mode, PCM audio is
		automatically recorded.

“DV AUDIO REC”Up to four audio signal channels can be input from a DV camcorder through the DV

“AUDIO1”	IN connector (i.LINK). This VCR allows you to select and record two of these channels.
ÒAUDIO2Ó	This setting is used to specify which two channels to record.
Ò1+2MIXÓ	When there are four DV audio channels (32 kHz):
	When there are four DV audio channels (32 kHz):
	“AUDIO1”: Records the two channels (L/R) of DV AUDIO 1.
	ÒAUDIO2Ó: Records the two channels (L/R) of DV AUDIO 2.
	Ò1+2MIXÓ : Mixes and records both DV AUDIO 1 and 2.
	When there are two DV audio channels (48 kHz):
	Because there are only two channels, those two channels are recorded regardless of
	the DV sound setting.

“OPTICAL OUT”	This VCR can send the Dolby Digital bitstream or PCM Audio to external devices.
“Dolby D”	When you play back a tape including the Dolby Digital bitstream, and if you have a
Ò2CH-PCMÓ	device equipped with Dolby Digital decoder, set this function to ÒDolby DÓ.
ÒSTREAMÓ	If not, set this function to Ò2CH-PCMÓ.
	ÒSTREAMÓ will be used when playing back and receiving a audio signals in other
	new formats.

IN(L-2)

Note for connection: Remove the protection cap from the cable.

CONTINUED ON NEXT PAGE A