46 EN
A/B/C/D
ABC
STOP
VCR
TV
CABLE
/DBS
2 - 2
2 - 1
5
2 - 3
1
IN F-1
+
[POWER] [PLAY (3)] The Remote is capable of controlling four JVC video
recorders independently. Each of VCRs can respond to one
of four codes (A, B, C or D).
This Remote control is preset to send A code signals because
your VCR is initially set to respond to A code signals. You
can easily change your Remote and the VCR to send and
respond to B, C or D code signals.
When using four JVC VCRs, set the four VCRs and their
Remotes to different codes, so that the Remotes can operate
these VCRs separately.
1Set remote operation mode
Set the [VCR/TV/CABLE/DBS] selector to [VCR].
2Set remote control code for Remote
1Press and hold [A/B/C/D].
2Press the ‘Number’ key [1] for A code control
signals, [2] for B code control signals, [3] for
C code control signals and [4] for D code
control signals.
3Press [STOP ( 7 )], and release [A/B/C/D].
3Turn off VCR
Press [POWER] on the VCR.
4Check remote control code for VCR
Press [PLAY (3)] on the VCR for more than 5
seconds.
● The code currently set appears on the front
display panel.
5Turn on VCR
Press [POWER] on the Remote.
●The code transmitted from the Remote blinks
for a few seconds on the front display panel.
●After the code disappears on the front display
panel, make sure that the VCR is turned on by
pressing [POWER] on the Remote.
To control four VCRs with the same Remote
You can control four JVC VCRs by switching the remote
control code for the Remote between A, B, C and D
(step 2), keeping four VCRs to different control codes.
●Press the ‘Number’ key [1] for A code control signals, [2]
for B code control signals, [3] for C code control signals
and [4] for D code control signals. (To change only the
remote control code for the Remote, DO NOT perform
steps 3 to 5.)
ChangingRemote ControlCode(Ex.) To set Remote to B code:
Press in succession
Hold
down
Release
NOTE:
When “POWER SAVE” is set to “ON”, you can not change the
remote control code. Before changing the code, set “POWER
SAVE” to “OFF” (
page 39).