Connection and Start-up
The following section is specifically intended for the specialist dealer. You only need to read this section, if you are carrying out the installa- tion yourself.
You will find sample configurations in the section "Connection exam- ple".
First, carry out all installation work before connecting the receiver to the mains power supply.
Refer to the information provided in the section "Safety instructions“.
Connecting receiver
Sat-IF connection
Connect the
Use a coaxial cable with a standard F connector for this purpose.
If you need to fit the
When fitting the connector, make sure that no wires of the shield braid make contact with the inner conductor. This could otherwise cause a
The quality of the reception signal depends on a good connection!
Preconditions for receiving signals
Make sure that your satellite antenna system is equipped with at least one universal LNB to facilitate digital reception in the high band range.
Presetting of receiving system
The control signals for conventional receiving systems (satellite dishes) are preset, i.e. 14/18 V for polarisation changeover and 22 kHz switching signal for LOW/HIGH band changeover on multifeed re- ception systems.
The presetting will need to be changed in the installation menu, menu item "DiSEqC," if UFOmicro or tone burst switching matrices are used in the receiving system.
Refer to the section "Installation menu, DiSEqC menu“ for this pur- pose.
It is important, that you observe the operating manual for the used ma- trix.
14
