Kathrein UFD 540 manual Command of Remote Control

Command of Remote Control

	The remote control features 2 command sets, making it possible to
	operate 2 receivers independently of each other in one room (not in
	conjunction with a twin receiver).
Note	For this purpose, program one receiver on the command set 1 and the
	second receiver on the command set 2.
	Switch on receiver 1 and receiver 2 off with the mains switch
	Press and hold the button.
	Enter in "901" with the number buttons.
	To adopt the code, press the button to switch receiver 1 to
	standby and then switch off the device with the mains switch.
	Put receiver 2 into operation again.
	Press and hold the button.
	Enter in "902" with the number buttons.
	To adopt the code, press the  button to switch receiver 2 to
	standby and then back into operation. Now switch on receiver 1 again.
	Press and hold the button.
	Enter in "903" with the number buttons.
	When carrying out the first two settings, the remote control must be di-
	rected at the respective receiver (when switched on).
	By pressing the button, you can now switch between the two
	command sets A and B (toggle function) and alternately operate both
	receivers.
	Command set 1 is always active as the on-delivery setting.
	If you are operating only one receiver and the active command set is
	switched over by mistake so that this receiver can no longer be oper-
	ated, the remote control can be easily switched back to command set
	1. The procedure is already described above.

10