Kathrein UFD 540 manual First Time Installation, First steps, Factory setting of receiver

First Time Installation

The first steps

Connect the receiver to the mains power supply.

Switch on the receiver by pressing the power button on the front of the unit.

The display, "- - - -,“ appears in the LED display.

When the LED for the operating display is red, the television is in standby.

Switch on the receiver by pressing the button on the remote control.

The orange LED on the front panel of the receiver flashes each time a button on the remote control is pressed.

You will see the factory set programme on your TV screen. An infor- mation bar indicating the programme provider, the time, the timer set- tings, the programme status and the programme title will be displayed in the bottom section of the screen, provided the corresponding data is transmitted. The number of the programme memory appears in the LED display.

The red standby indicator goes out.

You can now receive the factory set TV and radio programmes and call them up by pressing the buttons. Press the and buttons to select radio programmes. Press the

or button once more to return to TV programmes.

Refer to the section " Channel list –Radio/TV" for information on how to set up and save other TV and radio programmes.

When the receiver is switched on, t he reception status, which was last set, always reappears.

Please check the time of day for summer or winter.

If the message "bad or no signal" appears on the screen in addition to an on-screen display indicating the programme last received, you will need to check the system installation and/or the receiver settings. If this problem only applies to individual programme slots, the problem may be due to an interruption in the transmission signal or a fault in the receiving system (cable or satellite system).

In this case, first check the connection configuration and then check whether the basic settings of you receiver are correct for your system. If necessary, have a specialist do this for you.

Factory setting of receiver

Your receiver is pre-programmed to receive the ASTRA and HotBird satellites as well as Eutelsat 10E and 16E, TurkSat 42E, Telecom 5W and 8W. You will normally not need to make further settings. If you are not connected to a communal or party system, you need a multifeed arrangement with at least two LNBs in front of the satellite dish, in or- der to receive several satellite systems. Please ask your dealer.

Before you change the basic settings of your receiver, note down the settings in the form provided at the end of this operating manual. You will then be able to restore the original settings at any time.

16