Setting System Parameters
DiSEqC [UFO] Set-up
You should only make changes in this menu, when the receiver is connected to another receiving system with different features or if changes have been made to the receiving system.
Pay close attention to the instructions of your Sat IF system. Before each change, you should note the settings on the form at the end of this operating manual.
Press the menu buttons , and to open the DiSEqC menu.
22 kHz signal
In this menu point you can determine whether the 22 kHz signal is to be used to switch over between the low and high frequency range of a satellite or between 2 satellite positions.
Tone burst and DiSEqC signal
A DiSEqC control signal is necessary if more than four control criteria are required in a receiving system.
The setting option, i.e. tone burst or DiSEqC, which is required, de- pends on the components of the receiving system.
Refer to the description of the components (switching matrices) of the receiving system..
63
