Installation Menu
Tone Burst
Here the 22 kHz signal can be set as follows:
Switching states for setting:
22 kHz Signal | High/Low | ||
and |
|
| |
Tone Burst | Pos. A/B: | ||
Low |
| 22 kHz | Off |
High |
| 22 kHz | On |
Pos. 1 |
| Tone Burst | 0 |
Pos. 2 |
| Tone Burst | 1 |
|
|
|
|
Switching states for setting:
22 kHz Signal | |||
and |
|
| |
Tone Burst | |||
Pos | Tone Burst | 22 kHz | |
|
|
|
|
1 |
| 0 | Off |
2 |
| 0 | On |
3 |
| 1 | Off |
4 |
| 1 | On |
Switching states for setting:
22 kHz Signal | Pos. A/B | ||
and |
|
| |
Tone Burst | High/Low | ||
Low |
| Tone Burst | 0 |
High |
| Tone Burst | 1 |
Pos. 1 |
| 22 kHz | Off |
Pos. 2 |
| 22 kHz | On |
|
|
|
|
DiSEqC™
If the receiver is connected to a DiSEqC™ switching matrix, set the menu option to “On”.
The switching criteria and the input assignment of the DiSEqC™ switching matrices must be observed. You should therefore follow the description of the switching matrices or contact the engineer who installed the reception system.
DiSEqC™ Repeat
If the receiver is operated in a reception system with two or more
DiSEqC™ switching matrices connected in series (cascaded), the
DiSEqC™ command must be repeated.
In this case, set the “DiSEqC™ Repeat” menu option to 1 or 2.
Default setting: “Off”
UFO® mini
In a
The setting that has to be selected depends on the design of the
The setting is made according to the installation instructions for the
Remote Frequency
If you have set the UFO®mini menu option to “ON”, use this menu option to make the setting from the transmission frequency.
The transmission frequency to be set is specified in the installation manual for the
You should therefore be sure to follow the instructions given in the installation manual for the
81
