Installation Menu
DiSEqC™ [UFO] Setup
Pay attention to the bar at the bottom of the
22 kHz Signal
You should only make changes in this menu if the receiver is connected to a different reception system with different properties or if changes have been made to the reception system.
You should therefore carefully follow the instructions for your Sat IF system. However, before each change you should note the settings on the form at the end of this operating manual.
Press , and to access the DiSEqC™ menu.
This menu option is used to specify whether the 22 kHz signal is to be used to switch between the upper and lower frequency ranges for a satellite (low/high) or between two satellite positions.
Tone Burst and DiSEqC™ Signal
If more than four control criteria are required in a reception system, a
DiSEqC™ control signal is required.
Which of the setting options - Tone Burst or DiSEqC™ - is required depends on the components of the reception system.
You should therefore refer to the descriptions of the existing components (switching matrices) of the reception system.
80
