Installation Procedure
1.To prevent short circuits, remove the key from the ignition and disconnect the · terminal of the battery.
2.Make the proper input and output cable connections for each unit.
3.Connect the wiring harness wires in the following order: ground, battery, ignition.
4.Connect the wiring harness connector to the unit.
5.Install the unit in your car.
6.Reconnect the · terminal of the battery.
7.Press the reset button. (See p. 4)
2CAUTION
•If your car's ignition does not come with an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source that receives a constant voltage supply, as with battery wires, the battery may die.
•If the fuse blows, first make sure that the wires have not caused a short circuit, then replace the old fuse with one with the same rating.
•Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits do not remove the caps from unused terminals or from the ends of the unconnected wires.
•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.
•Insulate unconnected wires with vinyl tape or other similar material.
•Thoroughly wipe away oil and other dirt from the
installation surface.
Please avoid installation on uneven surfaces.
•Mount the unit so that the mounting angle is 30° or less.
•Do not install the receiver unit under the carpet. Otherwise heat
Using the Relay Connector (Accessory G)
1 Plug the vehicle's harness into | 3 Lock the cable clamp. |
the relay connector. |
|
2Plug the parking brake detection wire into the relay connector.
4Press down using pliers until the conductive metal is even with the plastic surface.
5Lock the lid.
|
| Cable clamp |
|
Vehicle | Relay |
| Lid |
connector | 3 | 5 | |
harness | 2 |
| |
|
| ||
|
|
| 4 |
| 1 |
|
|
| Detection wire |
| Conductive metal |
57
