Making connections

Installing the IEEE-1394 card in the host computer

Installing the Kodak Driver software

Installing the FireWire cable

Follow the instructions for installing the IEEE-1394 (FireWire) card and the Kodak driver software before you plug the scanner into the host computer.

IMPORTANT:You must install the software on the host computer before you connect the scanner.

Install the IEEE-1394 (FireWire) card according to the directions supplied with the IEEE-1394 card.

IMPORTANT: Use proper precautions to avoid static when you install the IEEE-1394 card in your computer. Make sure the computer power cord is disconnected.

1.Insert the installation CD in the CD-ROM drive. The installation program starts automatically.

2.Follow the on-screen instructions to install the TWAIN Datasource, ISIS Driver and the Kodak Scan Validation Tool.

3.Shut down the host computer.

An IEEE-1394 six-pin connector is provided on the rear panel of the scanner for IEEE-1394 connectivity.

1. Plug the end of the cable with the right angle into the scanner.

2.Connect the other end of the cable into the IEEE-1394 card outlet in the host computer. Be sure that it is installed correctly and properly seated.

CAUTION: DO NOT FORCE THE CONNECTOR. If the cable is not properly connected, it could cause damage to the scanner.

2-2

A-61500 May 2010

Page 12
Image 12
Kodak 6J7611A manual Making connections