NOTE: If calibration fails, check the Operator Log for details. See Chapter 6, “Accessing the Operator Log” for more information. You must wait at least 90 seconds before calibrating again.
Ultrasonics calibration Use only an A4 size /
perform an Ultrasonics calibration.
NOTE: The screens shown in this section are for the TWAIN Datasource. The screens displayed on your system may be different.
1.Center the side guides in the elevator tray and output tray.
2.Place the paper in the elevator tray in portrait orientation.
3.Follow Steps 5 - 12 above to access the Calibration dialog box.
4.Select Type: UDDS. Calibration begins. A confirmation box is displayed when calibration is complete
5. Click OK.
NOTE: If calibration fails, check the Operator Log for details. See Chapter 6, “Accessing the Operator Log” for more information.
