Kodak 8670 o o o o o, NIC Faceplate, Faceplate - Reset/Configuration Page Push-button Switch

Quick Configuration Reference Guide

NIC Faceplate

o o o o
o o o o o	Factory Reset/
Serial Config Port	Config Page
	10 BaseT/100BaseTX

Faceplate - Reset/Configuration Page Push-button Switch

The NIC has a single, recessed push-button switch located between the serial port and network connector. It has the following functions:

•To print a configuration test page, press the switch in for at least one- eighth second but less than five seconds

•To reset the unit back to factory default settings, press the switch and hold it in for at least 5 seconds.

Note: Reset and configuration pages can also be generated by using remote configuration utilities.

Faceplate - 10baseT/100baseTX Network Cable Connector

•A 100baseTX/10baseT RJ45 connector accommodates 100 Mbit (100baseTX) or 10 Mbit (10baseT) connectivity.

Faceplate - Serial Configuration Port

•The serial port may be used for NIC configuration and diagnostics.

Note: Remote configuration utilities are usually used instead of the serial port because the necessary computer resources are already on the network.

NIC LEDs (Not on Faceplate)

There are 3 LEDs, red, yellow, and green, located on the bottom of the NIC when it is installed in the printer. The back of the printer must be pulled out to view the LEDs.

2 June 1999