Kodak 8670 XConfig, Axconfig, SET NETW NPRINTER pserver number ON service SET NEW RESCAN EXIT

Novell NetWare

XConfig

1.Insert the diskette that came with the NIC into the disk drive. Enter:

A:XCONFIG.

2.Select the NIC from the list of print servers. Press ENTER when the message that the NIC is connected appears.

3.Enter the password access when the # prompt appears.

4.Press ENTER when the Enter Username> prompt appears.

5.When the Local> prompt appears, enter:

SET NETW NPRINTER pserver number ON service

SET NEW RESCAN EXIT

Pserver is the name of the printer/NIC on your file server. Number is the printer number which must match the printer number you selected during the PCONSOLE configuration in the previous steps. Service is the name of the service where the default service is KOD_xxxxxx. The xxxxxx is the last 6 digits of the Ethernet address. For example, to set up remote printer 3 on the NIC, KOD_00C3E4 using the printer/NIC called KOD1PS, you would enter:

SET NETW NPrinter KOD1PS 3 ON KOD 00C3E4 P1

SET NETW RESCAN

EXIT

NOTE: You cannot use the same service for both queue server mode and remote printer mode.

To enable remote printer capabilities on services other than the default NetWare services, define the new services that are enabled for NetWare and the desired port. Refer to Appendix A for more information.

6.Reload the PSERVER NLM from your NetWare file server console to apply the changes.

6-6 Part No. 6B4389 June 1999