Installing the Hardware
Requirements
You need the following to install the NIC:
•Network cabling certified for 10 and 100 MB operation. The NIC supports 10BaseT and 100BaseT cabling. Use category 5 unshielded twisted pair cabling for 100 MB operation.
•
•If a BNC (10Base2) connection is required, purchase a BNC/ RJ45 transceiver or hub from your local dealer or distributor.
•If a connection from a single computer to a printer is required, use a
NOTE: You can use an Rx/Tx crossover cable as a direct connection to a single computer without a hub. However, an Rx/Tx crossover cable is a nonstandard cable that may not be available from a local dealer. If you use an Rx/Tx crossover cable, make sure that it is clearly labeled so it is not confused with standard network cables for use with network hubs or switches.
Installing the NIC in an 8660 Printer
1. Turn off, and unplug the 8660 printer.
Part No. 6B4389June 1999Au- |