Follow the instructions for installing the IEEE-1394 (FireWire) card and the Kodak Driver Software before you plug the scanner into the host computer.
IMPORTANT: You must install the software on the host computer before you install the scanner.
An IEEE-1394 six-pin connector is provided on the rear panel of the scanner for IEEE-1394 (FireWire) connectivity.
1.Install the IEEE-1394 (FireWire) card in the host computer as described by the instructions included with the card.
IMPORTANT: Use proper precautions to avoid static when you install the
IEEE-1394 (FireWire) card in your computer.
2.Power up the host computer after the IEEE-1394 (FireWire) card installation is complete.
1.Insert the Kodak i200 Series Installation CD in the CD-ROM drive. The installation program starts automatically.
2.Follow the onscreen instructions to install the TWAIN and ISIS drivers and the Kodak Scan Validation Tool.
1.Attach the beaded end of the IEEE-1394 (FireWire) cable to the IEEE-1394 port on the back of the scanner.
WARNING: Make sure that the position of the IEEE-1394 (FireWire) cable connector end correlates to the IEEE-1394 port configuration before you plug the cable in. Damage to the scanner will occur if the cable is attached in the wrong position.
IMPORTANT: Only use the IEEE-1394 cable that is supplied with the i200 Series Scanner.
