Kodak A-61167 manual Circuit board cover

5.Remove the scanner’s output tray.

6.Lift up the scanner door release to unlatch the scanner door.

7.Pull up to open the scanner door.

8.Lift up the scanner door release again and open the scanner door past the circuit board cover.

Circuit board cover

9.Use a Phillips-head screwdriver to remove the two screws (one front, one back) that hold the circuit board cover in place.

NOTE: If the optional imprinter has been installed, disconnect the imprinter cable from the imprinter board before you remove the circuit board cover. Refer to Appendix C, Kodak i200 Series Imprinter, for information about the imprinter cable.

10. Lift up the circuit board cover and remove it.

E-2 A-61167 April 2005